After I rotate the photo box so that it is ready for me to select a vertical picture, the photo box stays vertical but the picture becomes horizontal when I insert it? I can get it to work but I have to use the image sizer. There has to be an easier way. Help!
I also tried to use the Inspector Photo Fill rotate to solve the problem but I could use it at all. What am I not doing correctly?
I think I like the program but I need some more practice. I wish there were more directions available.
Thanks for any help you can give me.
Page 1 of 1
Inserting Vertical Pictures & Using Inspector Using CM SBCStudio Software
#2
Posted 03 December 2010 - 11:27 PM
What program are you using? That will help us figure out how to help you.
Oh, and welcome to Scrap Girls!
Nancy
Oh, and welcome to Scrap Girls!
Nancy
#3
Posted 04 December 2010 - 07:44 AM
I don't know the answer to your question, but just wanted to say welcome to Scrap Girls.





#4
Posted 04 December 2010 - 08:28 AM
There will probably be someone to answer your question if you tell us what software you are using. Welcome to Scrapgirls!!

December 2010 Member of the Month
#5
Posted 04 December 2010 - 09:27 AM
Sorry I am using Creative Memories new program for the Mac, SbcStudio. At this point, I can't find much help for my problems.
#6
Posted 04 December 2010 - 08:59 PM
Hmmm. I'm not familiar with that program. Hopefully someone will be along soon to help out!
Welcome to Scrap Girls, however. It's nice to have you here.
Welcome to Scrap Girls, however. It's nice to have you here.
...Heidi D...
#7
Posted 04 December 2010 - 09:00 PM
I edited your topic's title so it will hopefully attract the notice of someone who uses that software!
...Heidi D...
#8
Posted 04 December 2010 - 11:19 PM
Sorry, I'm not familiar with this program either but I would like to welcome you to ScrapGirls! Let us know if you find the answer and I'll bump your thread up so maybe others will see it.
#9
Posted 05 December 2010 - 01:38 AM
A new program....don't know it. I bet someone on here does though. Welcome to ScrapGirls...bumping up the thread!


Share this topic:
Page 1 of 1

Help

















